Diagnostic Manual, Body and Accessories,
Volume 4.1
Diagnosis - Function Test
Test step/Test sequence |
Test condition |
Nominal value |
Possible cause/Remedy 1) |
1.0 Seat heating stage I |
Ignition: ON
Press front of left rear seat heater switch (S51/3) or right rear seat heater
switch (S51/4) respectively. |
Switch indicator lamp for stage I
lights up.
Seat cushion and backrest cushion warm up.
|
23 1.0, 3.0,
9.0
23
4.0, 5.0 |
2.0 Seat heating stage II |
Ignition: ON
Press rear of left rear seat heater switch (S51/3) or right rear seat heater
switch (S51/4) respectively. |
Switch indicator lamp for stage II
lights up.
Seat cushion and backrest cushion warm up noticeable more than in
stage I
|
23 1.0, 3.0,
9.0
23
4.0, 5.0 |
3.0 Dimming of indicator
lamps in stages I or II |
Ignition: ON
Rear seat heaters switched on.
Parking lamps switched on. |
Switch indicator lamp for stage I
or II lights up brightly.
Indicator lamps become dimmer.
|
23 8.0, 13.0 |
4.0 Seat heating switches
off with ignition: OFF
When engine is restarted, or ignition is switched on,the seat heater is
switched ON again automatically. |
Ignition: ON
Left rear seat heater switch (S51/3) or right rear seat heater switch (S51/4),
respectively in stage I or II
Ignition: OFF
Ignition: ON |
Seat heating: ON
Seat heating: OFF
Seat heating automatically: ON
|
23 1.0 |
5.0 Only with 8 or
12 cylinder engines
Increased CTP (idle) RPM with seat heating in
stage II.
|
Engine runs, seat heating switched
on.
Stage I
Stage II |
Idle speed increases approx. 100 RPM |
23 11.0 |
1) Observe Preparation
for Test, see 22. |
|