STI Home

Printable version

LOCATION:

16.3 Airbag (AB)   >   32 Control Module Programming - Parameters

After programming the vehicle equipment, the SRS MIL (A1e15) will continue to blink, indicating the need to set the parameters on the SRS control module (N2/2). Currently, the parameter set is identical for all models. The setting of the parameters can only be accomplished with the Hand-Held Tester (HHT). Setting Parameters: Change versions as necessary (as with programming control module). (example given): Vehicle with Airbag Programming: Set passenger side airbag to NO, Turn ignition OFF, then ON, Read out DTC memory, then erase DTCs, SRS MIL (A1e15) now blinks; set parameters via HHT. Note: After programming and setting SRS control module parameters, the SRS MIL (A1e15) will go out. CAUTION! To avoid damaging the SRS control module (N2/2), DO NOT interrupt the voltage supply to the control module while setting the parameters. Setting of parameters can only be performed once.