Diagnostic Manual, Body and Accessories,
Volume 5
Electrical Test Program - Preparation for Test (Seat Adjustment with Memory)
 CAUTION!
Injury hazard from pinching and crushing, in extreme cases extremities can even be severed when caught in the mechanism.
Do not allow any body parts to be in the general area of the moving components. |
Preparation for Test:
1. Review section 0, as well as  12, 20, 21, 31,
2. Battery voltage 11 - 14 V,
2. Check fuses - OK,
3. Prior to each connection or disconnection of connectors at the combination control module (N10-1), the battery ground cable must be disconnected (otherwise fault codes will be erroneously stored in DTC memory),
4. Ignition ON, or applicable door opened,
5. Voltage supply for control modules and CAN-data wiring OK (refer to D.M., Body and Accessories, Vol. 2.1, section 7.1 23),
6. Version coding correct (refer to 31).
Electrical wiring diagrams:
Electrical Troubleshooting Manual, Models 202/208; Volume 2, group 91,
Electrical Troubleshooting Manual, Model 210; Volume 2, group 91 |
 |
Test equipment; See MBUSA Standard Service Equipment Program
| Description |
Brand, model, etc. |
| Digital multimeter |
Fluke models 23, 77 III, 83, 85, 87 |
|
Printable version
