Listing of Test Steps

1	HHT with multiplexer to data link connector	connect/disconnect.
2	Throttle control	check throttle operation and condition. Lubricate bearings, gate levers and ball sockets.
2.1	WOT, CTP stop at pedal value sensor (B37)	check.
3	Selector lever position	P/N
4	Engine oil temperature	check.
5	ECT	check.
6	Ignition timing Engine: at idle	check (see Test and Adjustment Data, Section A).
7	Engine RPM at idle	check (see Test and Adjustment Data, Section A).
8.0	On/off ratio	check 1) .
8.1	CTP recognition (accelerator pedal not depressed)	check, HHT display ON 1) .
9	Closed throttle under load	check with selector lever in "D"(with service and parking brake applied) and consumers on.

1) Only possible using HHT (Test and Adjustment Data, section A). 15) Time Guide operation no. and/or SMS job no.

Note:
Refer to section B1, Engine Test and Adjustment, for Special Tools and connection diagram.