STI Home

Printable version

1.1  HFM Sequential Multiport Fuel Injectin/Ignition System (HFM-SFI)   >   32 Hydraulic Test Program - Test (Fuel System Pressure and Internal Leakage Test)

Test step DTC Test scope Test connection Test condition Nominal value Possible cause/Remedy 1) 1.0 Fuel pressure at idle (with vacuum) Pressure gauge connected to test connection. Engine: at Idle Valve on pressure gauge closed. 3.2 - 3.6 bar Check fuel pumps 33 , Replace diaphragm pressure regulator. 2.0 Fuel pressure at idle (without vacuum) Pressure gauge connected to test connection. Engine: at Idle Disconnect vacuum hose from diaphragm pressure regulator. 3.7 - 4.2 bar Replace diaphragm pressure regulator. 3.0 Fuel system leakage Pressure gauge connected to test connection. Shut off engine. After 30 minutes > 3.0 bar > 2.5 bar If the pressure drops quickly, replace check valve in fuel pumps. If the pressure drops slowly, check injectors 36 , Replace diaphragm pressure regulator or O-rings on diaphragm pressure regulator. 1) Observe Preparation for Test, see 22 .