| Test step |
DTC |
Scope of test
|
Test connection
|
Test condition
|
Nominal value
|
Possible cause/remedy
|
| 1.0 |
 |
Cruise control switch (S40)
V Decelerate/set
B Accelerate/set
SP Resume
A Off
Control switch contact |
79  (1.38)
79 (1.38)
79 (1.38)
79 (1.38)
79 (1.38) |
|
 51 (1.10)
72 (1.31)
52 (1.11)
74
(1.33)
43
(1.2) |
Ignition: ON
Switch not activated.
Position "DECEL"
Position "ACCEL"
Position "RESUME"
Switch not activated
Position "OFF"
Switch not activated.
Control switch contact in position:
"DECEL",
"ACCEL",
"RESUME",
"OFF".
|
< 1 V
11 - 14 V
11 - 14 V
11 - 14 V
11 - 14 V
< 1 V
< 1 V
11 - 14 V |
Wiring,
Cruise control switch (S40). |
| 2.0 |
 |
Stop lamp switch (S9/1)
Signal (N.C. contact) |
79 (1.38) |
N4/1
|
54 (1.13) |
Ignition: ON
Brake pedal not applied
Brake pedal applied |
11 - 14 V
<1 V |
Wiring,
Stop lamp switch (S9/1),
Base module (N16/1),
DM, Chassis and Drivetrain, Vol. 1, section 1.1
|
| 3.0 |
|
Stop lamp switch (S9/1)
Signal (N.O. contact) |
79 (1.38) |
N4/1
|
71 (1.30) |
Ignition: ON
Brake pedal not applied
Brake pedal applied |
<1 V
11 - 14 V |
Wiring,
Stop lamp switch (S9/1).
|
| 4.0 |
 |
Starter lock-out/backup lamp switch (S16/3)
(Transmission range recognition)
Voltage |
44 (1.3) |
N4/1
|
45 (1.4) |
Ignition: ON
Transmission range:
P 
R
N
D
3
2
|
1.0 V
0.3 V
4.0 V
3.5 V
2.5 V
1.8 V
(± 10 %)
|
Wiring,
Starter lock-out/backup lamp
switch (S16/3),
 4.1 ,
EA/CC/ISC control module (N4/1). |
| 4.1 |
|
Starter lock-out/backup lamp switch (S16/3)
(Transmission range recognition)
Resistance |
44 (1.3) |
N4/1
|
45 (1.4) |
Ignition: OFF
EA/CC/ISC control module (N4/1) unplugged.
Transmission range:
P
R
N
D
3
2 |
1400 
294
28000
11300
5900
3100
(± 10 %) |
Wiring,
Starter lock-out/backup lamp
switch (S16/3). |
| 5.0 |
 |
Left front axle vehicle speed
sensor (L6/1)
Speed signal |
79 (1.38) |
N4/1
|
56
(1.15) |
Lift front of vehicle.
Ignition: ON
Turn left front wheel by hand |
4 - 8 V~ |
Wiring,
Left front axle vehicle speed
sensor (L6/1),
ABS/ASR control module (N30/1)
DM, Chassis and Drivetrain, Vol. 2, section 5.2.
Note:
Upon completion of test, erase any DTC's from ABS/ASR control module (N30/1) memory. |
| 6.0 |
 |
Serial data bus (CAN) |
"L" |
N4/1x1
|
"H" |
Ignition: OFF
EA/CC/ISC control module (N4/1) unplugged.
Measure resistance at connector (see Figure 5).
|
55 - 65 |
Wiring,
LH-SFI control module (N3/2 or N3/3),
DM, Engine, Vol. 2, section 3.2,
Ignition control module (N1/4 or N1/5),
DM, Engine, Vol. 2, section 5.3.
ABS/ASR control module (N30/1)
DM, Chassis and Drivetrain, Vol. 2, section 5.2 |
Printable version
