STI Home
Body And Accessories
Chassis & Drivetrain
Engines
Diesel Engines
Info. / Comm.
Volume 1
Climate Control
Diagnostic Manual, Info./Comm., Volume 1
Printable version
LOCATION:
4.1 Antenna Systems (AS)
> 23 Electrical Test Program - Test
Electrical Test Program - Test
Test scope
Test connection
Test condition
Nominal value
Possible cause/Remedy
1.0
Noise suppression capacitor
Function
Ignition:
OFF
Radio:
ON
Tune-in a weak AM radio station.
Engine:
at Idle
No change in reception quality.
Replace noise suppression capacitor on right C-pillar.
2.0
RF antenna cable to radio (A2)
Continuity
Short circuit
(inner shielding)
Radio:
OFF
Disconnect antenna cable (b) between A2 and A2/16.
< 10
Wiring.
3.0
RF antenna cable to bumper FM antenna amplifier (A2/15)
Continuity
Short circuit
(inner shielding)
Radio:
OFF
Disconnect antenna cable (a) between A2/15 and A2/16.
< 10
Wiring.
4.0
Radio (A2)
Voltage supply
W0
A2/16
b
Radio:
OFF
Disconnect antenna cable (a) from A2/16.
Radio :
ON
11 - 14 V
Wiring,
A2 (see
3.1
23
).
5.0
Rear window AM antenna amplifier (A2/16) and bumper FM antenna amplifier (A2/15)
Total current draw
A2/16
A2
Connect ampmeter between A2/16 and control wire (c) from radio.
Radio:
ON
52 - 72 mA
5.1
If nominal value is okay, but reception quality is poor:
AM band
Replace A2/16 and perform
11
. If no improvement, replace rear window antenna.
FM band
7.0
5.1
Rear window AM antenna amplifier (A2/16)
Current draw
A2/16
A2
Connect ampmeter between A2/16 and control wire (c) from radio.
Disconnect antenna cable (a) from A2/16.
Radio:
ON
15 - 25 mA
6.0
,
A2/16,
If nominal value is okay:
5.2
5.2
Bumper FM antenna amplifier (A2/15)
Current draw
A2/16
A2/16
Connect ampmeter between A2/16 and antenna cable (a) from A2/15.
Radio:
ON
Note:
Voltage is supplied via the inner cable of RF cable.
37 - 47 mA
6.0
,
A2/15
6.0
Ground
A2/15
A2/16
Radio :
OFF
Note:
Do not loosen mounting connection on A2/15 or A2/16. Mounting connection also serves as ground.
< 1
Contact resistance at ground.
7.0
Antenna cable
Bumper antenna
Measure between connection on bumper (at solder connection) and pin on A2/15.
< 1
If nominal value is okay, replace A2/15 and perform
11
. If no improvement, replace rear bumper antenna.