Preparation for recalling actual values: 1. Fuses F1-22 and F4-3 ok, 2. Check fuse F4-8, F4-9 (for left front ESA control module (N32/1). 3. Check fuse F4-13, F4-14 (for right front ESA control module (N32/2). 4. Connect the Hand-Held Tester (HHT) to X11/4, according to diagram, see section 0. The diagnostic trouble codes (DTC's) can only be read out and erased using the Hand-Held Tester (HHT).

<

Actual Value	Possible cause	Test step/Remedy 1)
	Fore/aft switch (S91s1, S92s1)	23 3.0
	Rear raise/lower switch (S91s2, S92s2)	23 9.0
	Backrest fore/aft switch (S91s5, S92s5)	23 12.0
	Head restraint raise/lower switch (S91s4, S92s4)	23 15.0
	Memory button 1 switch (S91s6) (with memory button [S91s9]), S92s9 store memory	23 18.0
	Memory button 1 switch (S91s6, S92s6) recall memory	23 18.0
	Memory button 2 switch (S91s7) (with memory button [S91s9]), S92s9 store memory	23 18.0
	Memory button 2 switch (S91s7, S92s7) recall memory	23 18.0
	Memory button 3 switch (S91s8) (with memory button [S91s9]), S92s9 store memory	23 18.0
	Memory button 3 switch (S91s8, S92s8) recall memory	23 18.0
	Memory store button switch (S91s9, S92s9), pressed	23 18.0
	Circuit 15R	D.M., Body and Accessories Volume 1, 2.1, >23 >3.0
	Circuit 15	D.M., Body and Accessories Volume 1,2.1, >23 >2.0
	Left front door	D.M., Body and Accessories Volume 2, 5.2, >23 >5.0
	Right front door	D.M., Body and Accessories Volume 2, 5.2, >23 >6.0
	Hall-sensor for fore/aft motor (M27m1, M28m1)	23 5.0
	Hall-sensor for rear raise/lower motor (M27m2, M28m2)	23 11.0
	Hall-sensor for backrest fore/aft motor (M27m5, M28m5)	23 14.0
	Hall-sensor for front raise/lower motor (M27m3, M28m3)	23 8.0
	Hall-sensor for head restraint raise/lower motor (M27m4, M28m4)	23 17.0

1) Observe Preparation for Test, see 22.