STI Home

Printable version

LOCATION:

8.1 Parkronic System (PTS)   >   23 Electrical Test Program - Test

Test scope Test connection Test condition Nominal value Possible cause/Remedy 1.0   Ultrasonic PTS control module (N62) Voltage supply 10 N62 30 Ignition: ON 11 - 14 V Model 140: Fuse 4 in fuse box F4 Models 208, 210: Fuse 14 in fuse and relay box F1 Wiring 2.0   Diagnostic output 10 N62 27 Ignition: ON 9 - 14 V Wiring N62 3.0   PTS warning indicator (left instrument panel air outlet) (A44/1)       Ignition: ON Activate warning indicator using HHT All yellow and red segments in the warning indicator Illuminate Wiring A44/1 N62 3.1 3.1   Voltage supply 2 A44/1 3 Disconnect connector from PTS warning indicator (A44/1) Ignition: ON 11 - 14 V Wiring N62 3.2 3.2   Data line A44/1 1 N62 14 Ignition: OFF < 1 Wiring 4.0   PTS warning indicator (center instrument panel air outlet) (A44/4)       Ignition: ON Activate warning indicator using HHT All yellow and red segments in the warning indicator Illuminate Wiring A44/4 N62 4.1 4.1   Voltage supply 2 A44/4 3 Disconnect connector from (A44/4) Ignition: ON 11 - 14 V Wiring N62 4.2 4.2   Data line A44/4 1 N62 14 Ignition: OFF < 1 Wiring 5.0   PTS warning indicator (rear dome lamp) (A44/3)       Ignition: ON Activate warning indicator using HHT All yellow and red segments in the warning indicator Illuminate Wiring A44/3 N62 5.1 5.1   Voltage supply 2 A44/3 1 Disconnect connector from PTS warning indicator (A44/3) Ignition: ON 11 - 14 V Wiring N62 5.2 5.2   Data line A44/3 3 N62 25 Ignition: OFF < 1 Wiring 6.0 PTS sensor assembly (front or rear bumper) (A42b1 - A43b10) Voltage supply 2 A42b1 - A43b10 3 Disconnect connector from A42b1 - A43b10 Ignition: ON Models 140 and 210: 18 - 20 V Model 208: 7.5 - 9.5 V Wiring N62 6.1 6.1   Data line A42b1 - A43b10 1 Ignition: ON Activate data line using HHT Bar graph in multimeter pulses Wiring N62 7.0   Vehicle speed signal VSS 10 N62 7 Ignition: ON Rotate left front wheel > 3 V Wiring 8.0   Reverse signal 10 N62 26 Ignition: ON Select reverse gear > 7.5 V Wiring Starter lock-out/backup lamp switch (S16/1) Transmission range recognition switch (S16/10) 9.0   Light signal (circuit 58) 10 N62 6 Ignition: ON Lights: ON > 7.5 V Wiring