 
  
  Diagnostic Manual, Body and Accessories,
   Volume 3
  
Diagnosis - Diagnostic Trouble Code (DTC) Memory
| 
  
    | Preliminary work:
      Diagnosis - Function Test  11 Read out Diagnostic Trouble Codes, see section 0
 |  
 
 
 
  
    | Diagnosis Limit switch diagnostic trouble codes (DTC's) are only stored when the soft
      top stops moving during soft top operation and the switch is held depressed
      until the indicator lamp begins blinking. The exceptions are the switches
      for roll bar extended and roll bar retracted where the indicator lamp in
      the roll bar switch lights. DTC's 5 - 16 are considered limit switch DTC's,
      which do not necessarily mean the respective switch is defective, but rather
      should be interpreted as an indication of which limit switch signals are
      absent and are needed for the sequence to continue.
 
 
 Possible causes:
 
  Electrical fault (the last soft
      top or roll bar movement requested was completed). 
  Hydraulic fault (the last soft top
      or roll bar movement requested, did not occur). |  
 
 
|  |  
 
 
  
    | Diagnostic trouble code (DTC) | Possible cause | Test step/Remedy 1) |  
    |  | No DTC's stored. | - |  
    |  | Low voltage |  23  1.0 |  
    |  | Normal operating time exceeded |  23  3.0 |  
    |  | Illogical limit switch signals |  24 |  
    |  | Soft top compartment cover "locked"
      switch (A25/1s2) |  23  5.0 |  
    |  | Soft top compartment cover "closed"
      switch (A25/1s1) |  23  6.0 |  
    |  | Soft top storage compartment "open"
      switch (S84/5) |  23  7.0 |  
    |  | Soft top fabric bow "locked" switch
      (S84/8) |  23  8.0 |  
    |  | Soft top fabric bow "down" switch
      (S84/7) |  23  9.0 |  
    |   | Soft top fabric bow "raised" switch
      (S84/6) |  23  10.0 |  
    |   | Left front soft top "locked" switch
      (S84/1) |  23  11.0 |  
    |   | Right front soft top "locked" switch
      (S84/2) |  23  12.0 |  
    |   | Soft top "open" switch (soft top
      in storage compartment) (S84/3) |  23  13.0 |  
    |   | Soft top "overhead" switch (S84/4) |  23  14.0 |  
    |   | RB "retracted" switch (S83/5) |  23  15.0 |  
    |   | RB "extended" switch (S83/6) |  23  16.0 |  
    |   | Automatic deployment of roll bar
      has occurred |  23  17.0 |  
    |   | Power soft top switch (S84) |  23  18.0 |  
    |   | Vehicle speed signal |  23  19.0 |  
    |   | Circuit in control module (N52),
      solenoid valve, roll bar retracted | N52 |  
    |   | Circuit in CST/RB hydraulic unit
      (A7/5), circuit in RB rod side valve (Y57y10) |  23  2.0, 21.0 |  
    |   | Circuit in control module (N52),
      solenoid valve, roll bar extended | N52 |  
    |   | Circuit in RB piston side valve (Y57y11) |  23  23.0 |  
    |   | Circuit in control module (N52),
      power windows | N52 |  
  
    | 1) Observe Preparation
      for Test, see  22. |  |