Diagnostic Manual, Chassis and Drivetrain,
Volume 3
Diagnosis - Complaint Related Diagnostic Chart
Complaint/Problem |
Possible cause |
Test step/Remedy 1) |
ETS MIL (A1e35) or ABS MIL (A1e17) illuminates when engine is running. |
|
Read out DTC's, using HHT.
|
ETS MIL (A1e35) or ABS MIL (A1e17) illuminates while driving and does not go out. |
|
Read out DTC's, using HHT.
|
ETS MIL (A1e35) and ABS MIL (A1e17) illuminates while driving and then goes out. |
Vehicle system voltage < 11 V, too many electrical consumers in use. |
Check generator (G2),
Read out DTC's, using HHT. |
Brake pad wear indicator lamp (A1e6), low brake fluid/parking brake indicator lamp (A1e7), ETS warning lamp (A1e36), ABS MIL (A1e17), ETS MIL (A1e35) will not illuminate when turning ignition on. |
CAN data line. |
23 3.0,
Read out DTC's for instrument cluster |
ABS MIL (A1e17) illuminates with engine running after brake test or dynamometer use. |
Nonplausible rpm signal due to different rpm at front and rear axles. |
Read out DTC's, erase using HHT.
|
ETS MIL (A1e35) illuminates while driving and then after a while goes out (DTC code is stored). |
Rear brakes were overloaded at one time. |
Read out DTC's, erase using HHT.
|
1) Observe Preparation for Test, |
|