Instrument Cluster
| Complaint/Problem |
Possible cause |
Remedy/Test step 1) |
| Entire instrument cluster (A1) not functioning. |
Power supply,
Electronic circuit board.
|
 23  1.0 |
| Indicator lamps for ABS, ASR, roll bar, charge control, brake pad wear, brake fluid, parking brake and ADS are not functioning. |
Power supply,
Electronic circuit board.
|
23 1.0 |
| Instrument cluster illumination not operating. |
Bulbs ( 23 , Figure 2),
Exterior lamp switch (S1),
Electronic circuit board.
|
23 2.0 |
| Fuel tank gauge (A1p2) inaccurate or not operating. |
A1p2,
Fuel level sensor (B4).
|
23 3.0 |
| Fuel consumption gauge (A1p10) inaccurate or not operating. |
A1p10,
Fuel consumption signal from CFI, LH-SFI, engine control module (HFM-SFI).
|
23 4.0 |
| Engine oil pressure gauge with warning lamp (A1p3) inaccurate or not operating. |
A1p3,
Oil pressure sensor (B5).
|
23 5.0 |
| Engine oil pressure gauge with warning lamp (A1p3) stays on continuously. |
Oil pressure sensor (B5),
Electronic circuit board.
|
23 5.0
23 6.0 |
| Tachometer (A1p5) inaccurate or not operating. |
A1p5 |
23 7.0
|
| Low engine oil level indicator lamp (A1e12) lights up but oil level is OK. |
Oil level switch S43)
|
23 8.0 |
| Electronic speedometer (A1p8) inaccurate or not operating. |
Electronic circuit board 2) ,
A1p8,
Transmission inductive speed sensor (L2),
Vehicle speed signal from ABS or ASR control
module (N30 or N30/1).
|
23 9.0 |
| Outside temperature display (A1p4) inaccurate or not operating. |
Electronic circuit board 2) ,
A1p4,
Outside temperature sensor (B14).
|
23 10.0 |
| ECT gauge (A1p1) inaccurate or not operating. |
A1p1
ECT gauge sensor (B13)
|
23 11.0 |
Printable version
