Diagnostic Manual, Engines, Volume 1
| LOCATION: |
C Diagnostic Equipment > 37 Connection diagrams - Electronic Ignition (EI) system (distributor-less) |
Connection diagrams - Electronic Ignition (EI) system (distributor-less)
Note:
 The following section applies to Hermann engine analyzers, tests and connections for Bear DACE engine analyzers are similar, please refer to instruction manual supplied with the EI (distributor-less) test adapters.
When diagnosing starting or warm up complaints, do not check engine at operating temperature, instead proceed according to specific complaint.
Connection method:
Set engine analyzer to cylinder 1, select primary or secondary and test each ignition circuit
The primary and secondary ignition systems can be tested. The ignition coils are equipped with a mounting slot (Figure 2) for the kV (pickup) sensor. The primary pattern can be picked up using the primary adapter lead (Figure 3), or through a connection from the socket box to the ME-SFI engine control module.
Air filter
Ignition coil covers on top of valve covers
Primary side connections:
Disconnect engine harness from selected ignition coil
(T1/1 - T1/8 or T1/1 - T1/12) and install primary adapter cable (A)
in between selected ignition coil (T1) and engine harness
Primary leads with yellow (a) and green (b) connectors (from primary adapter cable) to primary leads on engine analyzer
Secondary side connections:
Kilovolt (pickup) sensor (C) to selected ignition coil (T1) mounting slot
Kilovolt clamp connector from engine analyzer ( Note: kV clamp must
first be removed) to secondary adapter cable connector (d [3 pole])
Secondary adapter cable connector (1- pole) to kV (pickup) sensor
connector
Remove, install
Remove, install
Connect, disconnect
Connect, disconnect
Connect, disconnect
Connect, disconnect
Connect, disconnect |
 |
Equipment
| Hermann Electronics 1) |
Datascope D950 or D960 S |
| Automotive Diagnostic 1) |
Bear DACE 40-960A |
Electronic ignition (EI) System (distributor-less) adapter 1)
Includes: Kilovolt clamp and kilovolt pickup harness with trigger
clamp for no. 1 cylinder, TN-adapter harness, primary ignition adapter harness
and operating instructions. |
Hermann CD 1222 2)
Bear 43-324 (ref: DACE CD 1222 BA) 2) |
Adapter set ME-SFI 1.0
Includes: Primary adapter cable for one cylinder, primary adapter cable (for DACE)
secondary adapter cable, kilovolt (coil) pickup |
Hermann CD 1230 2)
Bear 43-324 2) |
1) Refer to the MBUSA Standard Equipment Program.
2) Equipment supplied with EI (distributor-less) adapter may vary from equipment listed above, refer to MBNA Standard Equipment Catalog for complete listing. |
|
Printable version
