Preparation for Test: 1. Ignition: ON, 2. Side windows open, 3. Fuses ok for PSE control module, electronic ignition switch (EIS), 4. Battery voltage 11 to 14 V, 5. Review C/1, 20, 21, 22, 31, 32,

Test step/Test scope	Test condition	Nominal value	Possible cause/Remedy 1)
1.0 Locknut 1	Press "unlock" button on transmitter key.		See section 4.10 23
2.0 Locknut 2	Press "lock" button on transmitter key.		See section 4.10 23
3.0 Rotary tumbler/trunk lid microswitch (S88/1) (Model 140 only)	Trunk lid: Open Close		23 7.0
4.0 Lock vehicle via interior switch (CL) (S85/5)	Interior switch (CL): Press "lock" Not pressed		23 (PSE/CL) 2.0
5.0 Unlock vehicle via interior switch (CL) (S85/5)	Interior switch (CL): Press "Unlock" Not pressed		23 (PSE/CL) 2.0
6.0 Left/right front door switch (S17/3, S17/4) (Model 140 only)	Open left/right front door Close left/right front door		23 3.0
7.0 Left/right rear door switch (S17/5, S17/6) (Model 140 only)	Open left/right rear door Close left/right rear door		23 6.0
8.0 Left front door switch (S17/3) (Model 170 only)	Left front door: Open Closed		23 4.0
9.0 Right front door switch (S17/4) (Model 170 only)	Right front door: Open Closed		23 5.0
10.0RHR release switch (S52) (Model 140 only)	RHR release switch: Pressed Not pressed		See AD80.20-P-6003-01A
11.0Circuit 15 (Model 140 only)	Ignition: ON OFF		23 2.0
12.0Remote trunk release switch (S15) (Model 140 only)	Remote trunk release switch: Pressed Not pressed		See AD80.20-P-6002-01A

1) Observe Preparation for Test, see 22.