Diagnostic Manual, Chassis and Drivetrain,
Volume 1
Diagnosis - Diagnostic Trouble Code (DTC) Memory
Test Preparation for DTC Readout
| 1. |
Connect impulse counter scan tool to the data link connector (X11/4) according to the connection diagram as shown in section 0.
|
| 2. |
Read out any stored DTC's from ADS control module (N51).
Note: Connect yellow wire from impulse counter scan tool to socket 9 of N51.
|
 |
| Diagnostic trouble code (DTC) |
Possible cause |
Test step/Remedy 1) |
 |
No fault in system. |
In case of complaint:  23 (entire test) and 33 |
 |
ADS control module (N51) |
Replace N51 |
 |
Body acceleration sensor (B24) |
23  8.0 |
 |
Wheel acceleration sensor (B24/1) |
23 7.0 |
 |
Steering angle sensor (N49) |
23 9.0 |
 |
Left/right front axle damper valve assembly, front axle solenoid valve 1 (Y51y1, Y52y1) |
23 19.0, 20.0 |
 |
Left/right front axle damper valve assembly, front axle solenoid valve 2 (Y51y2, Y52y2) |
23 17.0, 18.0 |
 |
Left/right rear axle damper valve assembly, rear axle solenoid valve 1 (Y53y1, Y54y1) |
23 16.0 |
 |
Left/right rear axle damper valve assembly, rear axle solenoid valve 2 (Y53y2, Y54y2) |
23 15.0 |
 |
Not for U.S.A. vehicles. |
|
|
Not for U.S.A. vehicles. |
|
|
Vehicle speed signal (VSS) from ABS or ABS/ASR control module) |
23 4.0 |
|
Oil level switch (S44) |
23 5.0 |
|
Steering angle sensor (N49) not initialized |
23 10.0 |
| 1) Observe Preparation for Test, see 22. |
|
Printable version
